If you have the same thermostat control, it should be (relatively) easy. You probably don’t need to swap the faucet. It’s dripping because of the thermostat.
Comment on Can I replace my shower controls?
zkfcfbzr@lemmy.world 1 year agoThank you for the detailed response.
Is there any way I could accomplish part of my goal without getting into the complex work you described? For example, what if I left the controls alone but tried to replace just the faucet, for the drip issue? Or if I were able to locate the exact same controls, would it still require all of that work to replace them? I ask that question because the pressure knob is slightly broken, after being overtightened in an attempt to slow the drip. I’m concerned it may eventually break more completely.
bstix@feddit.dk 1 year ago
cedarmesa@lemmy.world 1 year ago
You can replace internals on your shower valve. Im not sure what brand that valve is but…first shut off your water at the main. Open your hot and cold side on your sink faucet. Go outside and open a spigot. This will drain down your pipes. Underneath the handle will probably be a tint set screw which is probably a small allen screw. Loosen this and remove the handle. Then there may be a decorative ring over the valve body (an escutcheon). Remove this if it has one. There will either be a threaded ring or the whole valve body will rotate. Unthread this assembly. Now the guts of the valve will be in your hand. Typically youre going to find 2 small black seals held in place by 2 small springs. These being worn out is whats causing the leak. They sell replacement seal and spring sets at the plumbing repair section at you local orange big box store. Reverse procedure after installing new springs and seals. Its helpful to know the brand and model of your shower valve to get the right seals. If not, take the old ones in and match them up. Id consider this to be a homeowner friendly repair and if you get confused or shit looks weird put shit back together and call a professional. Discretion is the better part of valor.
Macaroni_ninja@lemmy.world 1 year ago
The drip is the reason of the valve failure. It can be a limescale issue or just simply an old valve. Whatever part is controlling the waterflow (control unit, cartridge, etc) can be replaced if its still available.
Contract the manufacturer for spare parts advice and they should also have instructions on how to replace it.