Comment on My new m.2 ssd

• skuzz@discuss.tchncs.de ⁨1⁩ ⁨year⁩ ago

  [deleted]

  source

  • lazylion_ca@lemmy.ca ⁨1⁩ ⁨year⁩ ago

    Back in the 80s & 90s you had to configure settings like IRQ and bad sectors.

    source
• Kecessa@sh.itjust.works ⁨1⁩ ⁨year⁩ ago

  SATA is the interface that was mostly used until a few years ago, most people are used to seeing the version using cables (with an L shaped connector at both ends, still seen on 2.5" and 3.5" hard drives) but at some point they started making SATA drives using the m.2 form factor (with a connection similar to the one pictured in the OP) but the m.2 form factor is also used by other interfaces and not all of them are physically the same (the “expansion card” looks similar, the connection can be different), m.2 NVME drives are the ones mostly seen for storage space these days so most people assume that if storage is the m.2 type of will be NVME but sometimes (especially for laptops) it will be SATA that’s required instead (like in OP’s case)

  Picture of an m.2 storage drive can be seen here and there’s a keying section that shows the difference between B and M keys: en.m.wikipedia.org/wiki/M.2

  source

  • Lost_My_Mind@lemmy.world ⁨1⁩ ⁨year⁩ ago

    I still think of SATA as that new technology nobody has yet. I’m still used to IDE.

    source
• callouscomic@lemm.ee ⁨1⁩ ⁨year⁩ ago

  They said the b SATA m2 SSD key NVMe AFR actuator clusters the cache in m.2 U.2 mSATA PCIe made a SATA lata gata when she said 2.5" wasn’t big enough but 3.5" was too much and LBA LP MTTR spindles the motor with 28 pins when it lost a pin while bowling for transfer rate cause you failed to defragment your USB-connected PCIe Gen 4 pokemon with AHCI finding IOPs over 9000 so the HDD Teraflopped into the EDSFF pool and RAMmed itself 6 feet under.

  /s?

  source

  • Zeoic@lemmy.world ⁨1⁩ ⁨year⁩ ago

    He gets it!

    source
• ooterness@lemmy.world ⁨1⁩ ⁨year⁩ ago

  SATA= Slow (Max 6 Gbps) PCIe = Fast (Max > 100 Gbps in theory)

  This is the maximum rate from the drive to the motherboard. Many drives are fast enough that SATA works become the bottleneck. With PCIe, the drive can run at its full speed, whatever that may be.

  source