Comment on The torque better not be too strong with this one
Excrubulent@slrpnk.net 1 month agoI prefer to only use them when I can’t get alignment. They’re far more likely to round out the head in my experience, but they have their uses.
Comment on The torque better not be too strong with this one
Excrubulent@slrpnk.net 1 month agoI prefer to only use them when I can’t get alignment. They’re far more likely to round out the head in my experience, but they have their uses.
Croquette@sh.itjust.works 1 month ago
Maybe I didn’t use them enough yet, but I bought some Wiha balled hex driver and I haven’t stripped a screw yet, and I use cheap screws.
I also had to dismantle my 3d printer hot end with a lot of weirdly placed screws and it wasn’t even an issue.
Excrubulent@slrpnk.net 1 month ago
Fair enough, I’m talking about big H5 construction screws, so a different use case maybe. Also it turns out when ARRMA uses too much threadlock on their axle set screws you can strip them really easily, and I needed more expensive special hex drivers with tught tolerances to work with them.