Comment on bath time
pivot_root@lemmy.world 8 months agoThe funny part is that it wouldn’t even work.
If the plug was on a GFCI outlet, it would trip once neutral and hot are shorted.
If it wasn’t on a GFCI outlet, it would be an inefficient water heater. Current is inversely proportional to resistance, and an inch of tap water has a significantly lower resistance than a human body sitting at the other side of the tub. At American voltages of 110V, the worst thing that will probably happen is the wires heat up from the current passing through them.
It’s got a British plug so it’s at least 200 volts.
But yeah, probably ok if the water isn’t too salty and you stay away from touching the electrodes.
I’m still not getting in with one though. At over 6 feet, I take up the whole tub + most of the time anyway.
But yeah, probably ok if the water isn’t too salty
If you’re going to be passing a current through your bath water, you would want the bath water to be as conductive as possible. You don’t want the salt water in your body to be the path of least resistance. You want the current to flow around you, not through you.
Rivalarrival@lemmy.today 8 months ago
You assume the neutral wire is present and connected to the neutral prong, as it is in typical appliances. If I were to make this ducky, I wouldn’t connect anything to the neutral or ground prongs in the plug. Indeed, I’d connect all three wires in the cord to the hot prong.
pivot_root@lemmy.world 8 months ago
That is my first assumption, yeah. I did note at the end if they did intentionally not connect neutral and ground and it was a metal tub, that would work