Comment on Sunday SOTD Thread - January 19th, 2025 (#588)

• PorkButtsNTaters666@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

  Here we go:

  Image

  Image

  Still difficult to see, but on the second, the toe doesn’t touch the stone.

  source

  • gcgallant@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

    It looks to me as if it is cupped. In the first picture, the heel and toe are off the table and in the second the center is off. I’ve received razors with a similar amount of warp. By rolling the razor on the stone, you can generally get to the edge everywhere. You have to be diligent about it, though. If you use your vice, apply pressure very slowly and let the deformation you apply to the razor set in the vice for a few minutes before you remove pressure. I doubt that it would hurt to heat the blade up a bit but this is @djundjila’s domain more than mine.

    source

    • PorkButtsNTaters666@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

      As to heating up, what temps are we talking about as to not interfere with the tempering?

      source

      • gcgallant@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

        I honestly don’t know if it will make a difference. I would take a butane lighter and slowly heat the entire blade to the point where touching the edge with fingers is uncomfortable. This should be way below the temperature it would take to alter the temper.

        source

        • -> View More Comments
      • djundjila@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

        Tempering is usually done at around 500°C, so you’d definitely want to stay far away from those temps.

        source

        • -> View More Comments
  • djundjila@sub.wetshaving.social ⁨10⁩ ⁨months⁩ ago

    😬 😭

    source