I think the stamping is the body panels. They would still have to have a stamped metal frame to meet the S rating wouldn’t they?
Comment on Slate Truck is a $20,000 American-made electric pickup with no paint, no stereo, and no touchscreen
JillyB@beehaw.org 1 week ago
No paint because you’re injection molding body panels? Sounds good.
No stamping? How are you getting away with that? Are they just outsourcing the stamping for frame parts? There’s no way this thing doesn’t require stamped frame components.
Tbh, this feels like vaporware. I’ll believe it when I see them actually being delivered.
TransplantedSconie@lemm.ee 1 week ago
JillyB@beehaw.org 1 week ago
They make it sound like not having stamping is helping them by not requiring expensive machines and a factory with a high ceiling. I’m betting they’re outsourcing the stamping. I’m also betting that they won’t ever deliver a truck.
CanadaPlus@lemmy.sdf.org 1 week ago
Why not? I’d assume there’s a cast frame, and a thick piece of plastic will hold a person just fine (although I do wonder about bed durability in the back).
SteevyT@beehaw.org 1 week ago
Frame rails are usually stamped. Although low volume sometimes will brake press them.
CanadaPlus@lemmy.sdf.org 1 week ago
Hmm. Well, plastic can have a pretty good strength to weight ratio. Famously the best if you include fibres. If sheet metal can do it maybe they went all-plastic.
SteevyT@beehaw.org 1 week ago
At the cost of the mold to do something like that (and the machine to even run it), I’m reasonably sure that stamped or brake pressed frame rails make more sense cost wise. I’m not sure that volume will ever drive the cost of that low enough to be worth it within the life of a mold like that. Like, I can picture the design to make it a basic two plate mold (I think, I’m more used to parts that top out a bit over a foot in the largest dimension), but then the gate size and shot volume I’m picturing to fill the thing is just bonkers, although apparently there are a few machines in the world that could theoretically do it if I’m reading their specs right from a quick search.
Unless your thinking a carbon fiber layup, which is feasible, but I believe metal becomes more cost effective again at that point.
JillyB@beehaw.org 1 week ago
Definitely not cast. Some suspension parts are cast but most car frames are made from stamped sheet metal welded/bonded together.
madame_gaymes@programming.dev 1 week ago
My first as well. Feeding on the anti-Tesla hype to gain some clout and probably funding.