Comment on Thursday SOTD Thread - Sep 28, 2023
djundjila@sub.wetshaving.social 11 months agoVery close to a Fili 14.
Oh damn, that’s very high praise. I’m … skeptical 🧐
I’ve spent a bit of my lunch break honing mine, let’s see whether I can get it into a similarly praiseworthy state 🙂
gcgallant@sub.wetshaving.social 11 months ago
I understand completely! Back in April, I managed to get a 250nm nanocloth edge on the Bismarck. I did this by refreshing the edge using softer, less abrasive water stones from my collection, adding more edge trailing strokes, and stropping between the 8K and 12K, between the 12K and 250nm, and after the 250nm. I did not expect much, but I was stunned by how good this edge was, and how amazing the razor shaved. I decided that the slurry from the softer stones was a key factor in the result I achieved. Since then, I have been playing with using slurry to dampen forces and provide more gentle abrasion at the edge. This seems to have worked wonders on all edges that I have produced. I’ve spent a lot of time doing sharpness tests and microscope analysis to help verify overall improvement. The only time I don’t use slurry now is on final polishing on very hard stones (e.g. Black Arkansas, Jnats, etc.), and I have a ways to go to learn how far I can push an edge on these types of stones.
The edge on my Bismarck now, is a Jnat edge from a new stone that I received in August. Perhaps if I compared the previous synthetic edge to the new one I could tell a difference, but really, I can’t. Once you get a fine edge on this razor it transforms from “meh” to amazing.
djundjila@sub.wetshaving.social 11 months ago
See, I was happily using my single Naniwa 10’000/3’000 combination stone and a lapping plate, and now this puts me in danger of falling into a natural stone rabbit hole 😅
I’ll see how well my synth refresh or the edge worked, first 😀
gcgallant@sub.wetshaving.social 11 months ago
My hunch is that a truly well-formed edge feels and cuts the same way regardless of the stone combination used. At the end of the day we’re shaping metal using abrasion. Whether you use a synthetic material or a natural material to do this, the objective is the same. As you know, I test for sharpness and I use very high magnification to assess edge quality. When there is similarity in these results, the difference in edge feel using different stones (for me) is very small.